![]() ![]() Hold a bracket up to the wall so that the position of the rod lines up with your initial markings.Once you’ve factored in curtain length, window height, and width, proceed to install the curtain rod bracket. Skip this style if you plan to open and close your curtains regularly, as the bottoms will dirty quickly from constantly brushing the floors. If you plan to puddle your curtains for a look that is extremely formal, allow six to eight extra inches of fabric to fall at the bottom. To give the illusion of height in the room, mount the rod even closer to the ceiling. Don’t go higher than eight inches above the window frame any more than that looks awkward. ![]() Curtains that just graze the floor or sill appear classic and tailored, while those that break slightly at the floor (from one to three inches) are also on trend. You may need to adjust your penciled-in placement by an inch or two to get the panels to fall where you want them. If you can avoid it, you don’t want to have to alter the hems once you’ve mounted the rod. While measuring, keep in mind the length of your curtain panels. Repeat this in the middle of your window frame and in the right corner, then check your markings with a level. To find your ideal placement, measure down from the ceiling to the top of the trim at the left corner of your window mark the midway point. Wall-mounted rods are usually installed four inches above the window. Don’t forget to factor in additional wall space for decorative finials. Decide whether you’d like to mount the rod to the wall above or directly on the trim, which would allow you to still see some decorative woodwork.Ī general rule of thumb: For wall-mounted rods, allow at least one to three inches on each side of the window to accommodate an open curtain, or as much as six inches on each side of the frame if you’re trying to make the window appear larger. Once you’ve chosen the rod you need, measure the width of your window to determine the correct size to buy. It’s also available in a double-rod version to accommodate a top treatment, such as a valance. The U-shaped pole wraps around the entire window so that, when closed, the curtain completely blocks out incoming light. Opt for a double rod version if you’re interested in hanging inner sheers in addition to standard curtain panels. It’s ideal for hanging curtains with pole pockets, grommets, and tab-top headings. This adjustable pole attaches to the wall with brackets and often features an ornamental finial at each end. Pick out your curtains first, then pick one of the following rod styles that best suits your needs: ![]() Loosen set screw on bracket then insert rod in bracket and tighten set screw to secure rod in place.A successful installation starts with selecting the right rod for your desired window treatment.Drill pilot holes into wall with 1/4" drill bit and sink anchors, if necessary.Īlign brackets and screw in place to secure.Using brackets as guide, locate desired mounting position and mark on wall.įor best results place brackets 4" (10 cm) wider than your window frame and halfway between window frame and ceiling.Screw finials on rod and secure in place. Dispose of cap cover and any unused rod segments.For longer rod lengths: insert joint (E) into one of the end rod segments (G) and gently tap into place, add additional joints (E) and middle rod segments (H) and tap snug.Gently tap with mallet until rod segments are snug. For shortest rod length: insert joint (E) into one of the end rod segments (G) and gently tap into place.Ĭonnect the other end rod (G) and cover with protective cap (F).Measure window to determine the number of Zen curtain rod segments needed. ![]()
0 Comments
Leave a Reply. |